Search found 19 matches

what codec is used on the full screen view on the web page? I am able to see the thumb views when I logon with my windows phone but when I click on the camera for the full view it says invalid source. I have installed the cameras manufactures app and the sighthound web page still shows invalid source

Thanks, this worked great. just fyi for others trying it, the names of the cameras appears to be case sensitive.

I been having issues with cobwebs on the cameras and haven been turning off cameras to avoid the mass emails and recordings. it would be nice to have them automatically turn on after x amount of minutes or hours.

I would like to be able to have my security system disable and enable to email and ftp functions of sighthound like a master switch when I enable or disable the security system. the system would keep recording as normal while the security system is disabled but would not email or ftp.

I have a i7 4930K (~13100 benchmark) with 32gb and raid 5 storage and ssd system drive. I run 9 cameras with most running at 720p and I think three running at 1080p and the system runs at about 60 to 70% cpu all the time with 50% memory used. About 40Mbs is used on the ethernet card. Hard drive usag...

any chance of getting a windows phone app?

Hi rprobst, Thanks for the feature request. Unfortunately at this time Sighthound Video will not run on the raspberry pi 2. I'll forward your request to be considered for future releases. Regards, -Devin Is this because the raspberry pi 2 uses an ARM processor? I thought the one of main strength of...

the new raspberry pi 2 appears to be fast enough to support one camera. It comes with free windows 10. It has its own camera that can be attached. This could be a good all in one solution but I don't want to pay $60 to record video in high definition or to run rules. Can you setup a license for this...

I would like to have a run command for when an even stops. ie, you have a rule to detect people in the yard, the run command would kick off when it stops and again when it ends (with a different command) I would like to send a command to my home automation so the camera can tell it that it sees a pe...