Sricam AP008

[Venturemmltd]

I found these stream settings to work with this model:

http://"ip address"/videostream.cgi?rate=0&user="username"&pwd="your password"

Replace the information within the quotes with your information and remove the quotes.

Should look something like this:
http://10.0.0.145/videostream.cgi?rate= ... d=billybob

Enjoy.

[Devin]

Hi Venturemmltd,

Thanks for sharing! We'll be sure to add it to a future build of Sighthound Video.

Regards,

-Devin

[pk-in-wichita]

These are my notes to get Sricam AP008 running on my Zone Minder installation. Obviously, the IP's used are DHCP'd from my router.

This nmap command will get a list of all connections on the network:

Code: Select all

nmap -sP 192.168.29.0-255

Starting Nmap 6.40 ( http://nmap.org ) at 2014-12-27 11:18 CST
Nmap scan report for 192.168.29.102
Host is up (0.27s latency).
Nmap scan report for 192.168.29.103
Host is up (0.022s latency).
Nmap done: 256 IP addresses (2 hosts up) scanned in 27.13 seconds

This is the response for Sricam AP008 Camera

Code: Select all

nmap 192.168.29.103

Starting Nmap 6.40 ( http://nmap.org ) at 2014-12-27 10:51 CST
Nmap scan report for 192.168.29.103
Host is up (0.031s latency).
Not shown: 997 closed ports
PORT     STATE SERVICE
23/tcp   open  telnet
81/tcp   open  hosts2-ns
8600/tcp open  asterix

In Firefox (Opera does not work)

Code: Select all

http://192.168.29.103:81

GoAhead Server Prompt
user: admin
pass: <blank>

I found that the camera seems to drop configurations and reverts back to default settings. This makes good network security difficult at best.

I used Wireshark to sniff format sent for JPEG 640 x 480 picture being exported by the webserver. The following entry was used in Zoneminder (default user/password).

Code: Select all

snapshot.cgi?user=admin&pwd=&14197270862550.5094081442803144

-Steve