found that this camera will work with sighthound but it took some work
first off go into the supplied CMS software and configure the camera to allow rtsp on port 554 and also switch on UPNP if it isn't already.
once you have this then find out the ip address your router gives it and then use the following
network ip camera
other
configure manually
rtsp
your ip address and the port 554
this in the stream field
user=admin&password=YOURPASSWORD&channel=1&stream=0.sdp
obviously change YOURPASSWORD for whatever you have set up as a password
should also work on H264DVR camera designation
you still need to put your password and username in the relevant boxes
DB Power CAM0979_M or PO:38895
Moderator: Staff
2 posts
• Page 1 of 1
-
ipcamuser1 - Posts: 1
- Joined: Fri Sep 05, 2014 6:07 pm
Re: DB Power CAM0979_M or PO:38895
Hello,
Would you be able to provide a bit more info on this such as exact steps on how to configure and allow rstp on port 554 and switch on UPNP as I have no idea where this is as the CMS software they provide is awful and hard to navigate and I am fairly new to IP cameras etc in general, plus I would like to get this set up with sighthound before i make a purchase.
Many Thanks
Would you be able to provide a bit more info on this such as exact steps on how to configure and allow rstp on port 554 and switch on UPNP as I have no idea where this is as the CMS software they provide is awful and hard to navigate and I am fairly new to IP cameras etc in general, plus I would like to get this set up with sighthound before i make a purchase.
Many Thanks