Run external command when "Could not connect"

Like to see something in a future release? Post your suggestions here.

Moderator: Staff

no avatar
Posts: 1
Joined: Sat May 31, 2014 11:32 am

Run external command when "Could not connect"

by JeffW » Sat May 31, 2014 11:51 am


Once in a while one of my cameras need to be reset/restarted. It would be great if Sighthound would execute an external command when the camera is in "Could not connect" state. This would be a property on individual cameras.

What I would do is trigger an event in the home automation system that would switch power to the camera off and on.

It should probably retry a few times. Also presume it takes a minute or two for the camera to boot up.

As a workaround I could restart the cameras on a schedule, but this is not as nice.


Return to Feature Requests